How to maintain the stapling machine

While paying attention to the correct use of the nail box machine, pay attention to the correct maintenance of the machine, which is the key link to improve production efficiency and nail box quality, and cannot be ignored. Therefore, it is required to lubricate the bookings and punches on the machine once a day; The fixed shaft of the header and the fixed shaft of the left and right baffles should also be lubricated and cleaned with oil at any time; The upper and lower nail head drive shafts, bolt groove shafts and drive screws should also be well lubricated; The lower binding head is easy to accumulate in the punch due to part of the electroplating scraps falling off when the flat wire is sent in, so it should be cleaned frequently at ordinary times; After each month, open the header for cleaning and oiling; The 3 gears of the left and right baffles of the bolt slot shaft of the paper feeding belt should be greased once a month; Clutch and brake shall prevent oil and water from entering and infiltrating; The servo motor shall be kept clean to avoid dust accumulation; Clean the cooling dust filter screen of the servo motor driver frequently; The electrical control box must be kept clean to prevent short circuit fault caused by dust accumulation; The internal and external wire feeding wheel axles shall be lubricated with grease to keep them reliable and flexible; The gear and chain of power transmission shall be lubricated with grease once a month to prevent wear of mechanical parts.

The failure rate of semi-automatic case nailing machine is low, the reliability is high, and maintenance is very critical, so the following work should be done well:

1. The upper nail head punch shall be lubricated once a day, and the nail head shall be disassembled for cleaning and oiling every 30 days;

2. The lower nail head must be cleaned frequently and the nail head shall be disassembled because the small electroplating scraps of the nail line fall down and accumulate in the punch;

3. After cleaning and refueling, replace it;

4. Three gears on the left and right baffles of the paper feeding belt bolt groove shaft, grease once every 30 days;

5. The clutch and brake shall be free of oil and water;

6. The servo motor must be kept clean to avoid dust coverage, and the cooling dust filter screen of the servo motor driver must be cleaned frequently;

7. The electrical control box shall be kept clean to avoid short circuit caused by dust;

8. The internal and external wire feeding axles shall be flexible and lubricated with grease;

9. The fixed shaft of the nail head and the fixed shaft of the left and right baffles must be cleaned and lubricated with oil when moving;

10. The upper and lower nail head drive shafts, bolt groove shafts and drive screws are lubricated with oil.